Revised 08.2021
3-21
Operator’s Manual: 405 SLD Seed Express
™
Bulk Seed Tender
®
®
39
7. Using the remote control unit or the control
panel, slightly raise the conveyor from the
transport position.
MMG-00322b
8. Using the remote control unit or the control
panel, rotate conveyor to align the triangular
indicator on the conveyor pivot plate with the
alignment plate on the frame, as shown.
MMG-00324
NOTICE
The indicator mark and the alignment plate must be
aligned for the conveyor arm locking pin to engage.
This pin locks the inner and outer tubes of the
conveyor arm together. These two tubes must be
locked together before releasing the conveyor hitch
receiver (ball coupling). If the tubes are not locked
together, the inner tube will slide down inside the
outer tube and will not come out of the ball catch.
9. To lock the conveyor arm tubes together, pull
the handle of the lock pin outward slightly and
rotate it 90° counterclockwise.
MMG-00328
1
2
39
7. Using the remote control unit or the control
panel, slightly raise the conveyor from the
transport position.
MMG-00322b
8. Using the remote control unit or the control
panel, rotate conveyor to align the triangular
indicator on the conveyor pivot plate with the
alignment plate on the frame, as shown.
MMG-00324
NOTICE
The indicator mark and the alignment plate must be
aligned for the conveyor arm locking pin to engage.
This pin locks the inner and outer tubes of the
conveyor arm together. These two tubes must be
locked together before releasing the conveyor hitch
receiver (ball coupling). If the tubes are not locked
together, the inner tube will slide down inside the
outer tube and will not come out of the ball catch.
9. To lock the conveyor arm tubes together, pull
the handle of the lock pin outward slightly and
rotate it 90° counterclockwise.
MMG-00328
1
2
Fig 34 - Unlatch the conveyor arm
Fig 35 - Protective cover
Fig 36 - Remote control handset
Fig 37 - Raise conveyor slightly
3.10 SELF-FILL LOADING
Using the self-filling feature, the compartments
can be loaded with the seed tender’s conveyor
from a storage box, storage bin, grain truck, or
other means.
1. Unlatch the conveyor arm from the transport
position.
2. Remove the protective cover from the seed
pan and hopper.
- It may be necessary to lower the hopper in
order to remove the cover.
3. Turn ON the control system.
4. Start the engine.
- Once warm, move throttle lever to run the
engine at full speed.
5. Slightly raise the conveyor from the transport
position.
- Use the handset or control panel.