Otherwise, the rods could bend and deform so
much that they can no longer be used as pump
levers for the jack.
#
To prepare the hydraulic jack: insert the
third rod of pump lever
1
for the jack into
the lug wrench extension.
#
Close pressure release screw
3
.
#
To do this, use the flattened section on pump
lever
1
to turn pressure release screw
3
clockwise to the stop.
%
Do not turn pressure release screw
3
more
than one or two full turns. Hydraulic fluid
could otherwise escape.
#
Insert pump lever
1
with the largest rod into
the recess on the jack and secure by turning
it clockwise.
#
Place the jack vertically beneath the jack sup‐
port points described below.
Jack support point, front axle
Jack support point, rear axle (example: chassis
up to 3.5 t)
Jack support point, rear axle (example: Cargo
Van and Passenger Van up to 4.0 t)
Jack support point, rear axle (vehicles 5.0 t)
224 Wheels and tires
Summary of Contents for Sprinter 2019
Page 7: ......
Page 19: ...ASpare wheel example 227 At a glance Emergencies and breakdowns 17...
Page 298: ......
