Several attempts may be required. You
should test every position for at least
25 seconds before trying another position.
Synchronising the rolling code
Observe the "Important safety notes"
(
Y
page 283).
If the garage door system uses a rolling code,
you will also have to synchronise the garage
door system with the integrated garage door
opener in the rear-view mirror. To do this, you
will need to use the programming button on the
door drive control panel. The programming but-
ton may be placed at different locations depend-
ing on the manufacturer. It is usually located on
the door drive unit on the garage ceiling.
Familiarise yourself with the garage door drive
operating instructions, e.g. under "Program-
ming of additional remote controls", before car-
rying out the following steps.
Your vehicle must be within range of the garage
door or gate opener drive. Make sure that nei-
ther your vehicle nor any persons/objects are
present within the sweep of the door or gate.
X
Turn the key to position 2 in the ignition lock
(
Y
page 139).
X
Get out of the vehicle.
X
Press the programming button on the door
drive unit.
Usually, you now have 30 seconds to initiate
the next step.
X
Get into the vehicle.
X
Press previously programmed button
;
,
=
or
?
of the integrated garage door opener
until the door closes.
The rolling code synchronisation is then com-
plete.
Problems when programming
If you have problems when programming the
integrated garage door opener, please note the
following:
R
Check the transmitter frequency used by
garage door drive remote control
A
and
whether it is supported. The transmitter fre-
quency can usually be found on the back of
the garage door drive remote control.
R
Replace the batteries in garage door remote
control
A
. This increases the likelihood that
garage door remote control
A
will transmit a
strong and precise signal to the integrated
garage door opener in the rear-view mirror.
R
When programming, hold remote control
A
at varying distances and angles from the but-
ton which you are programming. Try various
angles at a distance between 5and 20 cm or
at the same angle but at varying distances.
R
If there is another remote control for the same
garage door drive, perform the programming
steps again using this remote control. Before
performing these steps, make sure that new
batteries have been fitted in garage door drive
remote control
A
.
R
Note that some remote controls transmit only
for a limited period (the indicator lamp on the
remote control goes out). Press button
B
on
remote control
A
again before transmission
ends.
R
Align the aerial cable of the garage door
opener unit. This can improve signal recep-
tion/transmission.
Opening or closing the garage door
Once programmed, the integrated garage door
opener will assume the function of the garage
door system's remote control. Please also read
the operating instructions for the garage door
system.
X
Turn the key to position 2 in the ignition lock
(
Y
page 139).
X
Press button
;
,
=
or
?
which you have
programmed to operate the garage door.
Garage door system with a fixed code: indi-
cator lamp
:
lights up green.
Garage door system with a rolling code: indi-
cator lamp
:
flashes green.
The transmitter will transmit a signal for as
long as the button is pressed. The transmis-
sion is halted after a maximum of ten seconds
and indicator lamp
:
lights up yellow.
X
Press button
;
,
=
or
?
again if necessary.
Clearing the memory
Make sure that you clear the memory of the
integrated garage door opener before selling the
vehicle.
284
Features
Stow
ing
and
feature
s