The garage door opener is only available for cer-
tain countries. Observe the legal requirements
for each individual country.
The HomeLink
®
garage door opener is compat-
ible with most European garage and gate opener
drives. More information on HomeLink
®
and/or
compatible products is available:
R
at a qualified specialist workshop
R
via the HomeLink
®
Hotline
(0) 08000 466 354 65 or alternatively
+49 (0) 6838 907-277
R
on the Internet at http://www.homelink.com
Important safety notes
G
WARNING
When you operate or program the garage door
with the integrated garage door opener, per-
sons in the range of movement of the garage
door can become trapped or struck by the
garage door. There is a risk of injury.
When using the integrated garage door
opener, always make sure that nobody is
within the range of movement of the garage
door.
G
WARNING
Combustion engines emit poisonous exhaust
gases such as carbon monoxide. Inhaling
these exhaust gases leads to poisoning. There
is a risk of fatal injury. Therefore never leave
the engine running in enclosed spaces with-
out sufficient ventilation.
Programming
Programming buttons
Pay attention to the "Important safety notes"
(
Y
page 283).
Garage door remote control
A
is not included
with the integrated garage door opener.
X
Turn the key to position 2 in the ignition lock
(
Y
page 139).
X
Select one of buttons
;
to
?
to control the
garage door drive.
X
To start programming mode: press and
hold one of buttons
;
to
?
of the integrated
garage door opener.
The garage door opener is now in program-
ming mode. After a short time, indicator
lamp
:
begins to light up yellow.
Indicator lamp
:
lights up yellow immedi-
ately the first time button
;
,
=
or
?
is pro-
grammed. If the selected button has already
been programmed, indicator lamp
:
lights
up yellow after ten seconds have elapsed.
X
Release button
;
,
=
or
?
. Indicator
lamp
:
flashes yellow.
X
To program the remote control: point
garage door remote control
A
towards but-
tons
;
to
?
on the rear-view mirror at a dis-
tance of 5 to 20 cm.
X
Press and hold button
B
on remote control
A
until indicator lamp
:
lights up green.
When indicator lamp
:
lights up green: pro-
gramming is finished.
When indicator lamp
:
flashes green: pro-
gramming was successful. The next step is to
synchronise the rolling code (
Y
page 284).
X
Release button
B
of remote control
A
of the
garage door drive.
If indicator lamp
:
lights up red: repeat the
programming process for the corresponding
button on the rear-view mirror. When doing
so, vary the distance between remote control
A
and the rear-view mirror.
The required distance between remote con-
trol
A
and the integrated garage door opener
depends on the garage door drive system.
Features
283
Stowing
and
features
Z
