If you park your vehicle with the soft top down
and remove the key, the wind deflector and the
head restraints in the rear compartment retract
automatically. When you restart your engine
after having been parked, the wind deflector and
the head restraints in the rear compartment
extend again automatically.
AIRCAP cannot be extended or retracted if the
vehicle speed exceeds approximately
160 km/h.
Retracting AIRCAP
X
Turn the key to position 2 in the ignition lock.
X
Open the cover on the lower centre console.
X
Press AIRCAP button
:
.
The two indicator lamps on the AIRCAP button
go out. Wind deflector
;
retracts.
The head restraints on the rear bench seats and
AIRCAP draught stop
=
move to the lowest
position simultaneously.
If there are passengers wearing seat belts in the
rear compartment, the head restraints on the
rear bench seats and the AIRCAP draught stop
remain in the upper position.
Retracting the head restraints on the
rear bench seats from the driver's seat
To improve the rear view, you can retract the
head restraints on the rear bench seats individ-
ually (
Y
page 102). The wind deflector remains
in its current position.
Fitting/removing the AIRCAP draught
stop
Preparation
You will need a 4 mm Allen key to fit and remove
the AIRCAP draught stop.
Before fitting or removing the AIRCAP draught
stop:
X
Turn the key to position 2 in the ignition lock.
X
Open the folding roof fully (
Y
page 89).
X
Extend the head restraints in the rear com-
partment fully (
Y
page 102).
Removing
X
Use the 4 mm Allen key to turn the bolts on
both sides anti-clockwise by about 90° and
loosen them.
X
Pull the bolts out of the brackets on the head
restraints.
X
Pull the AIRCAP draught stop out of the guide
rails in the direction of the arrow. Make sure
that you pull the AIRCAP draught stop for-
wards slightly when doing so.
Fitting
X
Keeping the AIRCAP draught stop horizontal,
guide it into the slot between the head
96
Soft top
Opening
and
closing
