SP_Inst02 /02_20220208
Instruction Manual For ShellPa Pro (Model type : STMP)
Page(20/32)
Lifescience Dept. Menicon Co.,Ltd.
Number of Sets
Number of repeated “Stretch Time + Stop Time”
1 --- 100sets
conducted on order below,
First: Stretch Time
Second: Stop Time
F
irst and Second repeat on set “Number of
Sets”
. Please refer to
“
Fig. 1 number of set on
“Stretch
-Stop system
”
.
5.3. "Stretch-Stop system" mode Monitoring
You can check elapsed time on
“Stretch
-
Stop system Setting”
or “Stretch
-
Stop system Monitoring”
.
“Number of Sets” is integrated, but “Stretch Time” and ”Stop Time” reset every finished 1 set
( 1 set =
“Stretch Time”
+
”Stop Time”)
After finishing one cycle (stretch and relax movement),
“Stretch
-
Stop system”
changes from
“Stretch
Time”
mode to “Stop Time” mode.
Therefore, there is possibility to take “Stretch Time” take time
longer than setting time (refer to example).
And, “Remaining Time” is overview time (“Remaining
Time” is calculated time,
It is updated (recalculated) every time one set finishes.)
<Example>
Setting
“
Stretch time
”
: 10min.
One cycle time
(Parameter A of “Operating Parameter setting” )
: 15min.(900sec.)
Setting “Stretch time” is 10
min., but actually, it will
change from “Stretch Time” mode to “Stop
Time” mode
, 15min. (is the time when one cycle ends.) later.
5.4.
“Stretch
-Stop system
“
mode operation
Stretch Time=10min.
One cycle time:15min
On this point, change from “Stretch
Time” mode to “Stop Time” mode.
Stretch time
Stop time
1set = 1 number of sets
Fig.
1 number of set on “Stretch
-
Stop system”
1 set