4. Ensure that the
Active Folder
and
Active Record
in the
Status Bar
show the proper location where you want
to store the test data.
5. Touch the
Surge
icon to enter Surge test mode.
6. Set the
Configuration Options
icon to display the
Power Pack with ZTX
.
7. Touch the
Coil mode
icon then touch the
Arm Bar
icon (
DC IP
icon for single -coil testing).
8. The test start screen should look similar to the example shown below.
Fig 58:
Armature bar test start screen for Baker PPX30A.
9. Select a starting point armature bar to use as a reference. Typically, this will be bar 1, so the probe or fixture
contacts will be placed on bars 1 and 2.
Using Power Packs with Baker DX Testers
62
Baker Power Packs User Guide 71-061RC EN V2
www.megger.com
Summary of Contents for PPX30
