22. After clicking on the
Lead 1
button, you will see a message instructing you to move the
Test Select
switch on
the power pack to the
Lead 1
position. Adjust the switch as needed, then click on
OK
to continue.
Fig 25:
Surge Test lead selection message.
23. Next, you will see a message instructing you to press the power pack’s
Test (PTT)
button (or footswitch) to begin
testing lead 1.
24. Press and hold the
Test (PTT)
button and use the power pack’s
Voltage Output Control
knob to set the
waveform to the desired voltage level.
Fig 26:
Setting the voltage and waveform using the voltage output control knob.
25. When you have reached the voltage level and the software completes its test, a message dialog will appear
instructing you to release the
Test (PTT)
button.
26. Click on
Lead 2
then
Lead 3
in the
Run Surge
section to test each of those phases in turn using the process just
described. The software will lead you through the process as noted.
27. When you have completed testing all three phases, click on the
Close
button to return to the
Main
window,
Tests
tab.
28. Test results should be automatically saved.
Using Power Packs with Baker AWA Testers
30
Baker Power Packs User Guide 71-061RC EN V2
www.megger.com
Summary of Contents for PPX30
