Create a New Motor ID
1. Select the
Data
tab and
Nameplate
view on the right side of the
Main
window.
2. Click on the
Add
button to add a new Motor ID.
The screen capture below shows a new motor called Main Heater Blower Motor. Using best practices, all other
information available on the motor’s nameplate is entered into the
Nameplate
tab.
Fig 17:
Creating a new Motor ID.
3. After entering nameplate information, click on the
Save
button. The
Select Test ID
dialog box appears so you
can select the Test ID that was created for the new motor.
Fig 18:
Create New Test ID dialog.
Using Power Packs with Baker AWA Testers
www.megger.com 25
Summary of Contents for PPX30
