Megaleds Orphos, Installation Handbook, Page: 72 / 100

68
INSTALLATION HANDBOOK - NAVIGATION LIGHTS INTEGRATED SYSTEM
REVISION - 02 (MAY, 2020
th
)
PROBLEM CAUSE SOLUTION
4. The Anchor
Light does not
light up
(continuation)
7. F3 Fuse (5A) burnt
7. REPLACE F3 Fuse (5A) and VERIFY
the cause of occurrence. If necessary,
CONSULT Technical Support.
5. The
Front-Facing
Light does not
light up
1. The capsules of the Front-Facing
Light are damaged.
1. REPLACE the Front-Facing Light
Set (21), however CONSULT the Tech-
nical Support MEGALEDS.
2. The Central PCI Board (10) is dam -
aged or correspondent cable (WHITE)
is disconnected or damaged.
2. REPLACE the Central PCI Board
(10), however CONSULT the Technical
Support MEGALEDS.
3. The cable or connector between
the Front-Facing Light (21) that do not
light is damaged, broken or discon-
nected.
3. INSPECT and REPAIR or REPLACE
the damaged component, CONNECT
again, however CONSULT the Techni-
cal Support MEGALEDS.
4. The SB1 Switch is damaged or dis-
connected from terminal of the Boat
Power Electric Whip (46).
4.
INSPECT
and
REPLACE
the Switch
correspondent or CONNECT the corre-
spondent cable.
5. The Navigation Light correspon -
dent cable of the Boat Power Electric
Whip (46) is broken or damaged.
5. INSPECT and REPAIR the Naviga-
tion Light correspondent cable of the
Boat Power Electric Whip (46).
6. The Anchor Light correspondent ca -
ble of the Power Electric Whip (47) of
Female Connector (40) is broken, or
damaged in the pins, disconnected,
bad contact or oxidized.
6. INSPECT and REPAIR the Power
Electric Whip (47), the Female Con-
nector (30) and/or Male Connector
(40) .