Megaleds Orphos, Installation Handbook, Page: 42 / 100

38
INSTALLATION HANDBOOK - NAVIGATION LIGHTS INTEGRATED SYSTEM
REVISION - 02 (MAY, 2020
th
)
1. STRIP OFF 2 inches (50 mm) the ends of each cable of the Power
Electric Whip (6 cables) (47) from the Female Connector (40). TWIST each end to
increase stiffness;
2. CUT 6 pieces of heat shrink tubing cables (thermal-retractable) with a
length of 4 inches (10 cm);
3. PLACE the piece of heat shrink tubing cables (thermal-retractable) in
each cable;
4. AMEND the ends of each cable of the two Electric Power Whip (46)
and (47), according to the 5 STEPS of figure 24A, considering the colors and
functions of each cable, respectively. OBSERVE the figure 24B.
ATTENTION! OBSERVE that each cable must correspond to a connec-
tion, according to TABLE 05 below, ie the cable of the Power Electric
Whip (46) must have the same function as the Power Electric Whip (47)
of the Female Connector (40), which originated from the factory.
TABLE 05 : COLORS AN FUNCTIONS OF EACH CABLE OF THE POWER ELECTRIC WHIP (47)
FEMALE CONNECTOR POWER ELECTRIC WHIP(47)
Cable color: Function:
BLUE REAR-FACING LIGHT
RED NAVIGATION LIGHTS (Port, Starboard, All-round White)
BLACK
NEGATIVE
GREEN ANCHOR LIGHT
WHITE FRONT-FACING LIGHT
BROWN POSITIVE OF THE HORN
5. WELD each amendment with soldering wire;
6. POSITION each heat shrink tubing cables (thermal-retractable) in the
middle of each welded amendment;