Medrad ProVis Mark V, Service Manual

Page: 108 / 143

Disassembly and Reassembly
16 - 1
Disassembly
and
Reassembly Procedures
This section contains recommended procedures for the disassembly
and reassembly of those portions of the injection system that can be
readily repaired in the field, along with part numbers and ordering
information for field replaceable components. If through troubleshoot-
ing and diagnosis, a repair or replacement procedure or component
which is not outlined in this section is required, contact MEDRAD Fac-
tory Service, or your local MEDRAD Service Representative.
WARNING: Hazardous voltages exist within the Mark V
ProVis Injection System that can shock, burn, or cause
death. To avoid injury, the system should be opened and
serviced by qualified service personnel only. Disconnect
the system from line power before cleaning or attempting
to perform any maintenance or repairs.
WARNING: Immediately disconnect the patient from the
injector if any system malfunction occurs. If a system mal-
function message appears, do not attempt to use the sys-
tem until the source of the condition has been identified
and corrected by qualified service personnel. Do not
attempt to recreate any fault conditions while connected to
a patient.
CAUTION: Electrostatic Discharge (ESD). Failure to follow
ESD protection practices may result in equipment damage.
ESD protection practices must be followed when servicing
any component of this system.
16
!
!