Medrad ProVis Mark V, Service Manual

Page: 122 / 143

Disassembly and Reassembly
16 - 15
Injector Head
- Syringe Heat Maintainer
(continued)
3. Install the wires/pins into the J29 connector housing (white -Pin 1,
black -Pin 2). Ensure that the tangs lock into place when inserting
pins into the connector housing. After installing the wires/pins, gently
tug on each wire to verify that the pins are secured in the connector.
4. Reconnect the P29/J29 connectors and the injector head to the
injector unit, and apply unit power. The heater should feel warm
within a few minutes. If the over-temperature light illuminates, place
the syringe heat maintainer on a pressure jacket; the light should
extinguish within a few minutes. If the over temperature light remains
lit, the assembly is defective.
5. After verifying correct operation, remove unit power. Reinstall the
bottom cover and retainer screws.