21
4-INSTALLATION AND ASSEMBLY
Technical Dept. - All rights reserved - Reproduction is prohibited
POSITIONING
Before installing the product assess the optimal position.
One can install the product in a pre-existing traditional fireplace or as a new system.
In addition to lift the product to the recommended height of 600 mm one can purchase a metal support separately (refer to the relative
optional accessories price list)
INSTALLATION IN A PRE-EXISTING FIREPLACE
Assess the following elements:
The supporting surface of the product must have the following characteristics:
• support the weight of the product and of any accessories
• consistency such as to allow anchoring by means of plugs for safety
• perfectly level
• the jambs as perpendicular as possible to the surface
The housing compartment must be large enough to accommodate the product.
After verifying the conditions needed for proper installation proceed with the installation of the product:
• fix the base of the product to the supporting surface
• carry out all chimney plumbing and electrical connections in compliance with the regulations in force.
Any space between the cladding walls and the product can be closed via a compensation frame that can be easily disassembled in the
event of maintenance of the insert.
It is mandatory to fix the product to the supporting surface, as otherwise the product could tilt when extracted.
One must check that all connections (plumbing and electrical) enable to extract the product.
INSTALLATION AS A NEW SYSTEM
Assess the following elements:
The supporting surface of the product must have the following characteristics:
• support the weight of the product and of any accessories
• consistency such as to allow anchoring by means of plugs for safety
• perfectly level
After verifying the conditions needed for proper installation proceed with the installation of the product:
• fix the base of the product to the supporting surface
• carry out all chimney plumbing and electrical connections in compliance with the regulations in force.
It is mandatory to fix the product to the supporting surface, as otherwise the product could tilt when extracted.
One must check that all connections (plumbing and electrical) enable to extract the product.
• Proceed to assemble the cladding.
It is best to leave the product without cladding for a few days to check the tightness of all plumbing connections.
For any type of installation, both on a new system as on an existing one, it must be possible to inspect the connections
of the hoses fitted on the wall, because when the product is extracted one must disconnect the pipes from the system.
