McHale
Fusion Vario
Baler & Wrapper
65
Type C
- The following applies to the fixed screw down stand (high hitch):
Stand type C is the only type supplied with the high drawbar hitch option and
is available as an option on the low drawbar hitch machines.
In order to elevate the drawbar, rotate the jack handle (1) in a clockwise
direction as shown below. In order to lower the drawbar, rotate the handle in a
counter-clockwise direction.
When the drawbar has been safely connected to the hitch on a high hitch style
tractor and the machine weight taken off the stand (by rotating jack handle (1)
in a counter-clockwise direction) the lower part of the stand (2) can be
retracted quickly by removing the quick-release pin (3) (having first removed
the R-clip (4)) and sliding up the lower part of the stand, fully into position.
Align the bottom hole and replace the pin (3) followed by R-clip (4).
The PTO chain support (5) holds the PTO shaft when disconnected from
tractor, in the storage position.
Depending on the height of the windrow being baled, the stand may need to
be elevated further, in order to avoid catching crop. This is done by rotating
the jack handle (1) in a counter-clockwise direction until it is fully retracted.
Type C - fixed screw down stand (high hitch)
3
4
1
2
5
