McHale
Fusion Vario
Baler & Wrapper
88
Wrapper too fast
This warning message will be displayed if the wrapper
speed goes above 40 rpm. Speed is factory set at 36 rpm
so this warning will not usually be seen unless the hydraulic
settings have been tampered with.
Contact your
McHale
dealer if you see this.
(2013)
Motor speed sensor
This warning will be shown if pulses are not seen from the
motor speed sensor, once the wrapper ring starts to rotate.
Contact your
McHale
dealer if you see this.
(2008)
1 dispenser film only
When the dispenser film sensor is switched on, failure of
one dispenser to feed film will flash this warning on the
display and the wrapping rollers will operate in 50/50 mode
giving a correct wrap with the remaining film roll.
Press ‘ESC’ to silence the alarm.
(2024)
Out of dispenser film
When both dispenser film rolls are empty, this warning is
shown on the display and the dispenser rotates slowly to the
loading position where the first roll is replaced.
. Press ‘ESC’ to silence the alarm.
(NOTE. The tone of this alarm/beeper is different to when
only one dispenser is feeding film, see the warning
message above).
(2019)
CAUTION: Ensure that the rear door switch is operating correctly.
The rear door switch warning should always appear on the control box
when the rear door is open. If this is not the case or if the warning
appears with the rear door fully closed, contact your McHale dealer.
