McHale
Fusion Vario
Baler & Wrapper
133
External tip control
There is an external tip control located on the back left corner of the
machine for the convenience of the operator when raising/lowering
the side-tip, without having to go into the tractor. The external tip
control is a double button switch, pressing and holding the upper
button raises the rear cradle at a slow speed and pressing and
holding the lower button lowers it, at a slow speed. The control box
must be in Manual mode.
Fitting the side-tip to the machine
1.
It may be easier when fitting the side-tip to lower the rear cradle halfway down.
This may be done either directly from the control box within the tractor, or using
the external tip control on the back left corner of the machine (control box must
be in Manual mode). Ensure that the tractor engine has been shut down, the
ignition key removed and the brakes applied.
2.
Secure the rear roller, using suitable lifting gear. Remove the rear cradle roller
chain guard. (
A
) Remove the M10 x 25 bolt from the end of the rear roller
sprocket. (
B
) Rotate the rear roller manually to locate the joiner link in the drive
chain. Remove the link and chain.
3.
Pull the sprocket out on the end of the shaft, as far as possible. (
C
)
4.
Remove the four M16 nuts and bolts, which hold the flange bearing. Fit the right
hinge mounting bracket (ACH01347) using four M16 x 55 bolts (CFA00349) and
nyloc nuts. (
D
) Ensure bolts are tightened fully.
5.
Refit the sprocket and secure using the M10 x 25 bolt. (
E
) Refit the drive chain
and joiner link. (
F
)
6.
Refit the rear cradle roller chain guard, having removed the pop-out section to
allow for the new bracket. (
G
)
A
B
C
D
