McHale
Fusion Vario
Baler & Wrapper
74
Bale counters
The bale count sub total is displayed on the top panel
of Screen 1. The control box contains ten different
bale counters (A-J) which can be reset and a grand
total counter which cannot be reset.
The current bale counter is set in the menu.
Voltage monitor
The control box monitors its operating voltage and
displays it on the right side of the top centre panel of
Screen 2. If the voltage falls below 11 volts the low
voltage warning message is flashed on the display.
Dispenser film wrapping
The selected number of rotations is displayed on the
top panel of Screen 1 (MAN/AUTO). The number of
rotations is adjustable in the menu options.
. When wrapping is switched to ‘On’ in
the menu, this icon will be displayed, showing the
preset number of rotations. If wrapping is switched to
‘Off’, this icon will not be visible. On the main section of
the screen, above the image of the Fusion, the number
of completed wraps and the target number of wraps is
displayed, when the wrapper is rotating.
Wrapper ring rotation speed (rpm)
The wrapper ring rotation speed, in revolutions per
minute, is displayed over the wrapper of the machine
image on the screen.
Bale diameter display
A bar graph shows the live bale diameter.
The first dashed line shows the minimum bale size
that can be wrapped (100 cm).
The second dashed line shows the maximum bale
size that can be wrapped (145 cm).
The bar graph is green when between these lines,
i.e. wrapping is allowed.
The bar graph turns red outside these lines, i.e.
wrapping is disabled (0 - 100 cm and 145 -
168 cm).
The actual bale size is displayed above the graph
at the start of netting.
