McDATA ULTRANET EDGE 3000, User Manual

Page: 98 / 428

5
5-22
McDATA UltraNet Edge 3000 User Guide
Configuring a 1x1 Ethernet Wide Area Network
• If you are creating a 1x1 configuration, the only selectable routing
type is Dedicated Circuit. All other options in this dialog box are
grayed out and ignored.
• The options selectable from this dialog box are limited by the
license key for the node. If the license key does not provide
support for the Fail Over and Load Balancing network routing
types, only the Dedicated Circuit network routing type is
selectable, and all other options on this dialog are grayed out.
• If you have not entered the licensing information for each node in
the circuit using the
License Wizard , only the Dedicated Circuit
network routing type is selectable from this dialog box.
• If you want to change the Network Routing Type after you have
created the data paths, double-click the F/C interface on the
Network Map. Click the
Network button at the bottom of the F/C
interface dialog box ( FC10 - Node10 ) and select the Network
Routing Type. You do not need to create the data paths again to
change the Network Routing Type.
The Create Data Path Wizard - Choose Data Path Options screen
appears.
6. E_port Disk Streaming increases performance in networks that
have a round trip latency greater than 10 ms. It moves data more
efficiently than our standard E_port solution. To enable the
E_port Disk Streaming feature, check the Enable Disk Streaming
check box.