McDATA ULTRANET EDGE 3000, User Manual

Page: 181 / 428

8
Configuring FICON Extension
8-9
Configuring a 1x1 Ethernet Wide Area Network
NOTE: The Serial Number is located on the front of the chassis and is used to
identify the UltraNet Edge 3000.
4. Click Apply to enable the maintenance interface. UltraNet
ConfigManager will load the IP address information into the
UltraNet Edge 3000 and will reboot.
NOTE: Watch the UltraNet Edge Configuration Status box for allocated and
assigned messages. These messages will only appear for a brief moment and
will indicate if the unit is resetting and booting up.
When finished booting up, the letters PMA will display and
remain in the Alphanumeric messages window until the
network configuration is delivered. Delivery is performed after
the configuration in UltraNet ConfigManager is completed.
NOTE: If a bootp message is not received within 45 seconds, you will get the
following Warning message. Use the procedure to manually configure the
Maintenance IP Port described in Appendix H.
IP Address of PC running UCM