McDATA ULTRANET EDGE 3000, User Manual

Page: 275 / 428

11
Product Support and Software Maintenance
11-13
UltraNet WebView Monitoring Application
To verify the current version of WebView on your UltraNet Edge
3000, follow the procedure “Verify your Current Software Version”,
found on page -2 in this chapter.
NOTE: WebView has been tested on the following operating systems and
browsers:
— Windows 98, NT, and 2000
— Internet Explorer 5.0, 5.5 and 6.0
Obtaining the UltraNet
WebView Software
Obtain the most current UltraNet WebView software release from
McDATA Customer Support and install it on the Windows PC used
to configure the network.
FTP WebView RPM File
to Root Directory
Use the following procedure to FTP the WebView software to the
UltraNet Edge 3000 root directory.
1. Use the FTP protocol to download the software from your PC to
the UltraNet Edge 3000.
2. FTP the UltraNet WebView software (.rpm file) from your PC to
the root directory of the UltraNet Edge 3000.
The FTP client must be set for the transfer type of binary. The FTP
client only requires a password if one was previously defined in
the UltraNet Edge 3000.
Install the WebView
Software
Use the following procedure to install the new software:
1. Telnet into the UltraNet Edge 3000.
2. Enter the correct password if previously defined.
3. Issue the following command at the UltraNet Edge 3000 prompt:
tm.0x10> upgrade -w wv xx .rpm
where:
xx
is the version of software you are upgrading to
example:
tm.0x10> upgrade -w wv32.rpm
where:
wv32
is WebView version 3.2
The software will be updated, the following is an example of the
context that will appear:
upgrade -w wv32.rpm
cfg envput _RPMCPUCheckDisabled YES