Table of Contents
Centauri user manual revision level 01 /2007
31
5.1.2.
Set Decoder
You can pre-set the decoder with 2 operational modes:
–
Dependency: ”remote”; to this the decoder sets itself to the parameter that it receives
from the distant encoder when the connection is made;
–
Dependency: ”local”; with this the decoder uses the locally set parameters;
To set the decoder, proceed as follows:
(a) Via the front panel:
•
Select the SETUP option in the Start mask (see
Figure 4
). The Setup mask appears.
•
Select
AUDIO DECODER
and press
. The following mask appears:
Figure 23:
The
DECODER
mask
•
Select the parameter to be changed with the
and
keys and then press the
key. A list of all possible values appears.
•
Select the desired value with the
and
keys and then press the
key.
•
Repeat this procedure if required for additional parameters.
•
Exit the parameter setting function by pressing the key.
(b) Via the remote control software:
•
Select
SETTINGS CODEC
. The following dialog window opens:
Figure 24:
The
CODEC SETTINGS
dialog window
•
Select the desired values under
DECODER
....
.
It is only possible to set the decoder parameter if ”Dependency” is set to ”local”.
•
To make the settings effective, click on ”OK”.
