7
ENGLISH
THERMOPOT MW-1056 GY
Electric thermos kettle (thermopot) is intended
for boiling water only. For proper and safe use of
the unit read these instructions carefully.
DESCRIPTION
1.
Water refill mark «Empty»
2.
Water level scale
3.
Water dispense ON-button
4.
Spout for pouring water
5.
Control panel
6.
Lid opening button
7.
Hand pump for water dispensing
8.
Steam release openings
9.
Lid lock
10.
Hand pump lock
11.
Removable upper lid
12.
Carrying handle
13.
Sealing gasket
14.
Maximal water level mark «FULL»
15.
Body
16.
Power cord connection socket
17.
Power cord
18.
Rotary base
Control panel
19.
Water boiling mode indicator «Boiling»
20.
Keep warm mode indicator «Keep warm»
21.
Reboil ON-button «Repeat»
22.
Water dispense ON-button «Dispense»
Attention!
For additional protection it is reasonable to install
a residual current device (RCD) with nominal
operation current not exceeding 30 mA. To install
RCD, contact a specialist.
SAFETY MEASURES
Before using the thermopot, read this instruc-
tion manual carefully and keep it for future
reference.
Use the unit for intended purposes only, as
specified in this manual. Mishandling the unit can
lead to its breakage and cause harm to the user
or damage to his/her property.
To avoid risk of electric shock, observe the
following safety recommendations.
•
Make sure that operating voltage of the unit
corresponds to the voltage of your mains.
•
The power cord is equipped with a “euro
plug”; plug it into the socket with reliable
grounding contact.
•
To avoid risk of electric shock, do not use
adapters for connecting the unit to the mains.
•
Do not use the unit in bathrooms. Do not use
it near swimming pools or other containers
filled with water.
•
Do not use the thermopot near heat sources
or open flame.
•
Place the thermopot on a flat stable surface;
do not place the unit on the edge of the table.
•
Do not place the unit near walls or furniture,
the distance between the unit and any other
surface should be at least 30 cm.
•
Do not use the unit outdoors.
•
Do not connect or disconnect the power cord
with wet hands, this may cause electric shock
or injuries.
•
Make sure that the power cord does not
hang from the edge of a table, or touch hot
surfaces.
•
When unplugging the unit, pull the plug but
not the cord.
•
Do not switch the unit on without water.
•
Use the thermopot only for water boiling. It
is prohibited to heat or boil other liquids in it.
•
Ensure that the water level is not below the
minimal mark and not above the maximal
mark.
•
Do not refill the thermopot during boiling or
right after it.
•
Do not fill the thermopot with water directly
from the faucet, use a suitable cookware
instead.
•
Do not drop or tilt the unit.
•
Do not leave the operating unit unattended.
•
Do not open the lid and do not pour water
during boiling.
•
Do not rotate the unit during water dis-
pensing.
•
Close the lid properly, but without excessive
effort.
•
Keep your hands away and do not bend over
the steam release openings, it may cause
scalding. Do not block the steam release
openings with any objects.
•
Do not lift the unit by the carrying handle dur-
ing water boiling, as it may cause scalding by
outgoing steam. Do not open the lid during
and right after water boiling.
•
Do not touch hot surfaces of the thermopot.
•
Be careful while carrying the unit filled with
boiling water.
MW-1056.indd 7
04.08.2015 12:50:07
Summary of Contents for MW-1056 GY
