PARTS INCLUDED
Part Image
Part Name
Quantity
Trim
1
Duct Bottom
1
Duct Upper
1
Phillips Pan
Head Sheet
Metal Screws
8
Phillips Flat
Head Wood
Screws
8
Questions? Call GE Answer Center at
800.626.2000
or
Visit our Website at:
GEAppliances.com
READ CAREFULLY.
KEEP THESE INSTRUCTIONS.
Installation
Built-In Trim Kits
Instructions
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT –
Save these instructions for
local inspector’s use.
•
IMPORTANT –
Observe all governing codes
and ordinances.
•
Note to Installer –
Be sure to leave these instructions with
the Consumer.
•
Note to Consumer –
Keep these instructions for future
reference.
• For easier installation and personal safety, we recommend
that two people install this microwave oven.
• Unplug the microwave oven before attempting installation of
this kit.
•
Skill level
– Installation of this appliance requires basic
mechanical and electrical skills.
•
Completion time
– 30 minutes – 1 hour
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered
under the Warranty.
TOOLS YOU WILL NEED
#2 Phillips
screwdriver
Pencil
Tape measure
Drill with
7
⁄
64
” bit or #35
FOR YOUR SAFETY
WARNING
Before beginning the installation, switch
power off at service panel and lock the service disconnecting
means to prevent power from being switched on accidentally.
When the service disconnecting means cannot be locked,
securely fasten a prominent warning device, such as a tag, to
the service panel.
WARNING
This oven must be plugged into a properly
grounded 3-hole, 120 volt receptacle as required by the
National Electric Code.
MODELS
JX1095STBB, JX1095STSS
31-7000180 Rev. 1 06-22 GEA
