Matrox DigiSuite LX MAX, User & Installation Manual

Page: 87 / 160

75
Configuring your DigiSuite LX MAX
Configuring your DigiSuite LX MAX
Once you’ve installed the DigiSuite software as explained in Chapter 6 ,
you must use the DigiSuite Configuration program to customize your input
and output settings. Remember that if you’ve connected several inputs to
your DigiSuite LX MAX, you’ll have to change the settings in the
Configuration program every time you want to switch from one connection
to another. For more details, see
“Configuring the video input signal” on
page 81 .
Using the DigiSuite Configuration program
When you ran DigiUtils Setup to install the DigiSuite software, your
DigiSuite LX was assigned default settings that are suitable for most
applications. The DigiSuite Configuration program lets you customize
these settings to meet specific video and audio input or output
requirements. For example, you may want to change the default proc amp
settings for your analog video input signal.
If you chose to install the VTR driver for DigiTools or you installed the
Matrox realtime plug-in for Adobe Premiere, you must use the DigiSuite
Configuration program to configure your VTR for RS-422 device control
with these programs. This is required to perform frame-accurate capture
and recording to tape.
°Important
Before starting the DigiSuite Configuration program, close
any program that uses DigiSuite, such as DigiTools or Adobe Premiere. If
you don’t do so, your system and audio/video signals may become
unstable.
¬
To start the DigiSuite Configuration program:
1 Choose Start > Settings > Control Panel .
2 Double-click the DigiSuite icon.