Matrix EPABX Vision-206S, System Manual

Page: 20 / 235

Matrix
20 Vision System Manual
Getting Started
Switching ON the Vision
Switch on the system. The reset cycle can be seen on the front panels of all the cards of the system. Test the
system for proper functioning by making internal calls to other stations and by making trunk calls.
Stations
Standard telephones instruments like Rotary phone, Pulse-tone switchable push-button phone, Feature phone,
CLI display phone or a Cord-less phone can be connected to the Vision. Hence, it is not necessary to buy all
new phones. Existing, old but working telephones can also be used.
Trunk Lines
Analog trunk lines can be connected to the system. Please ensure telecom earth to the system.
How to make a perfect earth?
• Dig a pit of area 2 feet x 2 feet x 6 feet. (lxbxd). Please refer to the figure on the next page.
• Get a copper plate of size 1.5 feet x 1.5 feet x 0.25 feet.
• Connect a copper strip of size 1-inch wide, 3 mm thick and 6 feet length at the center of the copper plate by
welding or nuts and bolts.
• Insert a G.I pipe onto the copper strip till it reaches the copper plate.
• Place this set up into the pit and ensure that at least 4 inch of the G.I pipe is above the ground level.
• Fill the pit 1-inch layer of charcoal and salt in 3:1 ratio at the bottom and then with the soil.
• Connect a bare 14 SWG copper wire (double) on the top of the copper strip and run it to the exchange room
and connect it on the bus bar.
• Bus bar is a copper strip 4-inch long with 6 nos. of screws and nuts mounted on it. It has to be fixed on the
wall in the exchange room.
• The earth wire of the system should be connected to this bus bar.
• It is recommended to water the earth at regular intervals.
Testing the Installation.
• In the Power ON mode the system is ready for use with predefined values for variables like extension’s
flexible numbers, timers and other programmable parameters.
• It is required to check the functioning of the system by testing all the extensions and the trunk.
• Test all extensions for dial tone, ring back tone, speech and ring one by one.
• Test functioning of the trunk by dialing outside number from one of the extensions and checking the trunk
tones and speech. Ring on the trunk can be tested by asking your friend to dial your number.
How to make an Internal Call?
• Lift the handset.
• Dial the desired extension’s flexible number.
• The called extension rings. You get a Ring Back Tone.
• Speech is established when the called party lifts the handset.
Important Points:
• Hands free Operation is also possible if a speakerphone is used.
• The extensions having access to internal call will only be able to make Internal Calls.
How to make External Call?
• Lift the handset.
• Dial trunk access code
• Dial the external Telephone Number.