Matrix EPABX Vision-206S, System Manual

Page: 180 / 235

Matrix
180 Vision System Manual
System Security (Passwords)
What’s this?
Vision’s programming/usage is secured at three levels:
• System Engineer level. This level is protected by SE password.
• System Administrator level. This level is protected by SA password.
• User level. This level is protected by user password.
System Engineer Password
• This password is the main password of the system and should be kept by the system engineer. SE
password is needed to enter the system engineer mode of the system to change any setting of the system.
• SE P/w is a 4-digit password. It cannot have either less than or more than 4 digits. Digits 0-9 are valid.
• Please note that the system engineer cannot know SA password or user password. However, he can clear
these passwords to their default values.
How to program?
Use following command to change SE Password:
1104-Old SE Password-New SE Password
New SE password is a number string of 4-digits.
By default, SE Password is 1234.
Forgot your program password?
• It is very important to remember the SE password. Without this password, it is not possible to enter the
program mode and change the settings. It is advisable to make a note of this password at a safe place.
• However, if the system engineer (SE) password is lost, then it can be set to its default value. Following steps
describe the procedure:
• Switch off the system.
• Locate a mini jumper on PCB.
• Put the jumper J8 in A-B Position.
• Wait for 15 seconds.
• Switch off the system.
• Open the system, restore the jumper in its original position (B-C) and switch on the system.
• The SE password gets default to
1234.
• Enter SE mode by dialing
1#91-1234.
System Administrator Password
• The system administrator uses this password.
• SA password is a 4-digit password. It cannot have either less than or more than 4 digits. Digits 0-9 are valid.
How to program?
Use following command to change SA Password:
1105-Old SA Password-New SA Password
New SA password is a number string of 4-digits.
By default, SA Password is 1111.
User Password (User Security)
The User can secure his station from unauthorized use by way of using User Password
For operational details on this topic, please refer ‘User Security (User Password)’.
Relevant Topic:
1. Programming the System 143
=X=X=