Entrée Bath Gen III -
MODEL MB-68 AV-XL
OPERATION MANUAL
10-20-19
Page 19 of 51
450 E 32
nd
Ave – Fremont, NE 68025
800-798-5867 FAX: 402-721-3023
www.mastercarebath.com
Thumb Screws:
The thumb screws hold the service panel in
place and are to be removed only by authorized service
personnel for service access.
Liquid Dispensing Controls
: These controls are used to add
Bath Oil and Shampoo directly into the bath water.
Drain Handle / Overflow
: It is used to drain the tub and to
manage tub overflows.
BATHAIRE
(SM)
VARIABLE SPEED SYSTEM
CONTROL
BASIC OPERATION:
BathAire
(SM)
On/Off Button:
The BathAire
(SM)
can be turned on
or off by pressing the on/off button. Press the button once and
the BathAire
(SM)
will turn on. Press the button once again and
the BathAire
(SM)
will shut off.
BathAire
(SM)
More & Less Air/Heat Buttons:
Once the
BathAire
(SM)
is on, it is in an adjustment mode. The BathAire
(SM)
starts on at 60% of full volume. To increase or decrease the air
volume, press the air/heat + button and hold down to increase
level or the air/heat – button to decrease level until the
desired level is achieved. The heat level is tied to the air
volume and adjusted the same way.
BathAire
(SM)
Wave Mode:
To create a wave effect: Press the
wave button once for the long cycle, a second time for the
short cycle and a third time to return to normal operation.
BathAire
(SM)
Purge Cycle:
The purge cycle comes on
automatically 20 minutes after the BathAire
(SM)
system has
been turned off to remove any residual water from around the
aeration valve. It will then run for a period of one minute. This
is a preset of the motor and cannot be turned off. It also is
programmed to cycle every 24 hours, so be aware it will run
the purge cycle 24 hours after BathAire
(SM)
being energized.
FOOT-END CONTROLS
Liquid
Dispensing
Controls
Liquid Dispensing
Drain Handle
/ Overflow
Thumb Screw
BathAire
Controls
On/Off
Button
Wave
Button
Less Air/Heat
Button
More Air/Heat
Button
