Entrée Bath Gen III -
MODEL MB-68 AV-XL
OPERATION MANUAL
10-20-19
Page 21 of 51
450 E 32
nd
Ave – Fremont, NE 68025
800-798-5867 FAX: 402-721-3023
www.mastercarebath.com
OPERATION
Before operating the Entree Bath,
familiarize yourself with the key
features of the tub outlined in the
drawings supplied with these
instructions.
BATHING PROCEDURES
1.
Fill the Reservoir:
a.
Make sure the Reservoir Fill Control
Valve is in the closed position.
b.
In the Console Controls, set the
Reservoir Fill button to Auto and the
Rapid Fill button to Fill Reservoir.
c.
Bring the water temperature up to
normal bath temperature by placing
the shower Spray inside the bath,
turned toward the tub side wall. Then
turn on the Shower Spray Control
Valve. Run the water until it reaches
the desired temperature; adjust the
water temperature between 96° to
105° by turning the Mixing Valve
toward the hot or cold side. Turn off
the Shower Spray Control Valve and
replace the Shower Spray.
WARNING: The temperature
of the bath water must never
exceed 110°. If you are
unable to adjust to the
normal level of 100° to 105°,
remove the individual and
report the problem to
maintenance. Do not use
bath until the mixing valve is
serviced to correct the
problem. Failure to heed this
warning could result in a
scalding injury to the
individual
d.
The Reservoir Fill will shut off
automatically when the reservoir is
full.
Reservoir Fill
Button
Rapid Fill
Button
CONSOLE CONTROLS
FOOT-END CONTROLS
Mixing Valve
Reservoir Fill
Control Valve
Door Open
Button
Console
Controls
Tub Fill and
Shower
Spray
Shower Spray
Control Valve
Liquid Dispensing
Controls
Door Close
Button
Tank Temperature
Thermometer
Tub Water
Thermometer
Emergency Door
Open Button
