Masimo Rad-87, Operator'S Manual

Page: 27 / 101

Rad-87 Pulse CO-Oximeter Operator’s Manual 3-1
I n t r o d u c t i o n
Before the Rad-87 Pulse CO-Oximeter can be used in a clinical setting, it needs to be
inspected, properly setup and the batteries need to be fully charged.
U n p a c k i n g a n d i n s p e c t i o n
Remove the instrument from the shipping carton and examine it for signs of shipping
damage. Check all materials against the packing list. Save all packing materials, invoice
and bill of lading. These may be required to process a claim with the carrier. If anything is
missing or damaged, contact the Technical Service Department. The contact address and
phone numbers are listed in Section 9,
Service and Repair .
P r e p a r a t i o n f o r m o n i t o r i n g
The following sections of the manual describe the preparation, set-up and initial installa-
tion of the Rad-
87
Pulse CO-Oximeter.
RAD-
87
POWER REQUIREMENTS
Always use a hospital grade, AC power cable to connect the Rad-87 to an AC power
source.
CAUTION: DO NOT CONNECT THE RAD-87 TO AN AC OUTLET CONTROLLED BY
A SWITCH.
Verify the AC power voltage and frequency before use. Verify that the power source can
provide adequate power rating as indicated on the rear panel of the Rad-87.
The Rad-87 is designed to operate on 100 to 240VAC, 47-83 Hz. The device is rated at
15 VA max.
Connect a hospital grade power cable to the power entry module of the Rad-87
device(IEC-320 connector type at the device). Connect the power cable to an AC power
source. Ensure that the device is adequately powered by verifying that the AC power
indicator on the Rad-87 is illuminated.
CAUTION:
■
CONNECT THE RAD-
87
ONLY TO A HOSPITAL-GRADE RECEPTACLE (FOR HOSPITAL
USE).
■
DO NOT UNDER ANY CIRCUMSTANCES REMOVE THE GROUNDING CONDUCTOR FROM
THE POWER PLUG.
■
DO NOT USE EXTENSION CORDS OR ADAPTERS OF ANY TYPE. THE POWER CORD
AND PLUG MUST BE INTACT AND UNDAMAGED.
■
USE THE POWER CORD AS THE MEANS TO DISCONNECT THE DEVICE FROM THE
MAINS POWER SUPPLY.
3-1
3
s e t u p