Model: MC-1-M (2U)
Doc. Ref. no. : - m05/om/101
Issue no. 14
Page 57 of 103
User’s Manual
ET1:
Additional Event1
ET2:
Additional Event2
ET3:
Additional Event3
ET4:
Additional Event4
•
Command: EWx
Applicable Options: EW1 / EW2 / EW3 / EW4 (Please refer ‘H’ Command menu for applicable
meanings of mentioned options)
This command is used to configure ON Time of Additional Events. These Events can be configured to
stay ON for a minimum 50 millisecond to 50% of its period. These configuration commands are listed
below:
EW1: Event1 ON Time
EW2: Event2 ON Time
EW3: Event3 ON Time
EW4: Event4 ON Time
Example:
1. If user has to configure event1 at every 60 seconds interval with pulse ON time width of 50
milliseconds of event time, below values are to configured for event1 output.
ET1 = 60
EW1 = 50
2. If user has to configure event1 at every 60 seconds interval with pulse ON time width of
20% of event time, below values are to configured for event1 output.
ET1 = 60
EW1 = 12000
3. If user has to configure event1 at every 60 seconds interval with pulse ON time width of
50% of event time, below values are to configured for event1 output.
ET1 = 60
EW1 = 30000
NOTE:
a) Unit of ETx parameter is seconds and EWx parameter is milliseconds (i.e. 1 sec = 1000
milliseconds). Please ensure that the instrument should be power switch OFF/ON after changing
the event time settings.
10.2.8 Ethernet Default Command:
•
Command: ETH0
It is recommended to remove all NTP outputs RJ-45 cable from network
before using this command and stop all the services such as NTP, SNMP,
Telnet with GPS Master Clock Model MC-1-M because this command will set
all NTP output ports IP address to same IP address as a result of which there
will be IP conflict in network.
