Model: MC-1-M (2U)
Doc. Ref. no. : - m05/om/101
Issue no. 14
Page 47 of 103
User’s Manual
option while doing communication parameters settings in HyperTerminal. User can check GPS Master
Clock Model MC-1-M COM2 communication settings from Keypad Menu available on front panel of GPS
Master Clock Model MC-1-M. Refer “USER CONFIGURATIONS” section in manual for keypad menu
operation.
The settings of the HyperTerminal must be set same as that observed on LCD to initialize the
communication. In order to re-configure the settings, first disconnect (refer page 42) the communication
on the HyperTerminal.
Figure 10.4: LCD Display - COM port Settings of GPS Master Clock Model MC-1-M
Figure 10.5: HyperTerminal Configuration
After connection is setup successfully, user can see the time frames coming from unit COM2 terminal on
HyperTerminal. By factory set, GPS Master Clock Model MC-1-M device is configured to provide NGTS
output at 9600(baud rate), 8 (data bits), N(Parity None),2 (stop bit) communication settings. NGTS output
will be transmitted at every minute with respect to GPS Master Clock Model MC-1-M time. Refer below
image.
------------------------------------------------
T1101022120101
T1101022120201
T1101022120301
T1101022120401
------------------------------------------------
Figure 10.6: NGTS Time frame on HyperTerminal Screen
