Mash Adventure 400cc, Owner'S Manual

Page: 37 / 42

XY400GY
-36-
Please use the alcohol to clean the bulb if with a bare
hand contact with the light bulb.ep the warming after
closing.
16. Rubber part of the cable
Rubber is around the cable outside, to protect the inner part.
Keep the cable in proper position. When cleaning, don’t
wash by water, but by cloth.
Disassembling and installation of Fr. wheel
Fasten the frame before disassembling the front wheel Jack
up the front wheel and loosen the bolt
【
1
】
on the right
front shock absorber, loosen the front wheel shaft
【
2
】
,
hold the front wheel, pull out the front wheel shaft,
speedometer
【
3
】
Caution:
- Do not operate the front brake lever when
disassembling the front wheel
-Make sure that the brake disc is always laid face-up
when lay down the wheel. Otherwise the brake disc
might be damaged.
To install the front wheel, lift it into the fork first, then
position and assemble the axle shaft
Loosen the clamp screws on the right shock absorber
slightly. Take the motorcycle down from the stand and press
the front wheel brakes and push down the fork for times to
make the shock absorber come into alignment.
Only after such procedure has been accomplished, tighten
the clamp bolt
【
1
】
on both shock absorbers with 15Nm
Warning
-If you find out that there is no maximum torque, please
contact your Shineray dealer to correct and tighten the
torque as soon as possible. A loose shaft may cause
instability when riding.
-After the installation of front wheel, please operate the
front brake lever continuously until the pressure is back
to normal.
-It is very important to keep the brake discs away from
oil or any fatty materials. Otherwise, the braking effect
would be largely reduced
-Tighten the bolt until it reaches the required torque, a
loose shaft may cause unstable performance of the
motorcycle.
Disassembling and installation of rear wheel
Jack up the motorcycle on its frame so that the rear wheel
can not reach the ground. Remove the nut
【
1
】
, and the
chain tensioner
【
2
】
and then, pull out the rear wheel
axle
【
3
】
until you can push the rear wheel forwards.
Take off the chain tensioned from the rear sprocket. Pull
out the wheel axle and remove the rear wheel axle from
the rocking arm carefully.
Caution:
-Do not operate the rear brake after the disassembling
of the rear wheel.
-Make sure that the brake disc is always laid face-up
when lay down the wheel. Otherwise the brake disc
might be damaged.
-If the axle is disassembled, please clean the thread of
the wheel axle and bolts thoroughly and apply a new
coat of grease to prevent the thread from jamming.
The installation of the rear wheel is in reverse
procedures. Before tightening the nuts to 80Nm, push
the rear wheel forward so that the chain pensioner
would lie on the tension bolts.
Warning
-If you find out that there is no maximum torque,
please contact your Shineray dealer to correct and
tighten the torque as soon as possible. A loose shaft
（
2
）
（
1
） （
3
）
【
1
】
【
3
】 【
2
】