Mash Adventure 400cc, Owner'S Manual

Page: 26 / 42

XY400GY
-25-
Adjustment of the free travel at the hand brake lever
The free travel at hand brake lever may be readjusted by
correcting the adjusting bolt
【
1
】
. The position of the point
of pressure can be adjusted in this way to fit any hand sizes.
When press the hand brake lever forward, please leave 3
mm space for free trave. If necessary, screw the bolt
【
1
】
tight.
Caution:
The free travel at the hand brake lever is at least be 3
mm . Only then may the piston in the hand brake
cylinder be moved. If this free travel is not effected,
pressure will accumulate in the braking system, and the
front brake might be failed to function because of
overheat.
Brake pads
：
The front and rear brakes are fitted with bushes, and these
bushes provide an optimal combining space, enhance the
performance of braking and extend the length of service life.
The type of these bushes is stated on the back of the brake
pads and also recorded in the homologation papers.
Other brake pads are applicable for racing games.
Brake discs
-Brake discs worn out greater than 0.4mm would
constitute a safty problem. Please have the brake discs
replaced immediately as soon as they reach the limit of
acceptable wear-out.
-The repair service of the braking system should be
performed by Shineray dealers.
Brake fluid reservoirs
The brake fluid reservoirs of front and rear brake is
designed in such a way that even if the brake pad are worn
out, the brake fluid will not be fully filled in the reservoirs.
If the brake fluid level drops below the minimum level,
the braking system may have a leak or the brake pads
would be completely worn out. In this case, please ask
your authorized Shineray dealers for help.
Brake fluid:
We recommend you to use the brake fluid which is
adopted by Shineray for its braking system.
Warning
Please have the brake fluid renewed once a year. If
10
～
20mm