![Marzocchi Shiver 50 Manual Download Page 88](http://html.mh-extra.com/html/marzocchi/shiver-50/shiver-50_manual_1734749088.webp)
86
IT
EN
4.10 Ricomposizione gruppo cartuccia
Inserire all’interno del tubo portante il distanziale di
precarica (17) e la molla (19).
N
OTA
È possibile variare il valore di precarico della molla seguendo
la procedura indicata al paragrafo 5.2.
Inserire il gruppo pompante completo (21) all’interno del
portastelo (11).
Montare la forcella in morsa fi ssandola per il piede
portaruota (70).
Spingere sul tappo superiore in modo tale che la parte
inferiore della cartuccia fuoriesca dal piedino portaruota.
Avvitare il dado di fondo (48) e serrarlo alla coppia prescritta
(vedi Tabella 5 - Coppie di serraggio) con una chiave a
bussola da 21 mm.
•
•
•
•
•
4.10 Re-assembling the cartridge
Insert the pre-load spacer (17) and the spring (19) inside
the stanchion tube.
N
OTE
It is possible to modify the spring preload value by following
the instructions given in paragraph 5.2.
Insert the complete pumping unit (21) into the slider (11).
Clamp the fork leg in the vice by the wheel axle clamp (70).
Push the top cap so that the lower part of the cartridge
comes out of the wheel axle clamp.
Tighten the bottom nut (48) and fasten it at the required
torque (see Table 5 - Tightening torques) with a 21 mm
socket wrench.
•
•
•
•
•
21 mm
17
19
21
11
48
70
Summary of Contents for Shiver 50
