SPARTAN IRONWORKER FLAT BAR SHEARING STATION
© MARVEL MFG. CO., INC. MANUAL
PL/OMiW-2CYL_V2
(08/07)
H-5
6.
Re-install the blades with an unused edge
in the cutting position. If all of the blade's
cutting edges are worn, install a new
blade.
7.
Continue with step 4 of "Adjusting the
Stationary Blades", below.
Adjusting the Stationary Blades
The stationary blades are adjustable so the correct
clearance between the stationary blades and the
moveable blade can be achieved.
Avoid serious injury.
Turn off the machine's power
and
lock
it
out
before
adjusting or servicing the
machine.
1.
Turn off the main electrical disconnect
switch and lock it in the "Off" position.
2.
Remove the two hand knobs (A) that
secure the guard / holddown and remove
the guard.
Remove the two handknobs to remove the guard /
hold-down.
3.
Remove the socket head cap screws (B)
that hold the work table in place.
Remove the socket head cap screws which hold
the work table to the machine.
4.
Position the following switches as
indicated:
o
Auto / Manual switch to "Manual".
o
Shear / Notch switch to "Shear".
o
Normal / Jog switch to "Jog".
5.
Close the notching station's guard.
6.
Turn on the Main Electrical Disconnect
switch.
7.
Reset the Emergency Stop pushbutton(s).
8.
Press the "Pump On" pushbutton.
Note: If the hydraulic pump does not come on
make sure the Emergency Stop pushbutton(s) are
reset.
Avoid serious injury.
When the foot switch is
pressed, the moveable blade
will descend. Keep away from
the blade.
Avoid damaging the machine.
Make sure the moveable blade
will not strike the stationary
blade.
Important: If it appears the moveable blade
will strike the stationary blade, continue with
step 10.
WARNING
WARNING
CAUTION
A
A
B
