SPARTAN IRONWORKER
BAR SHEARING STATION
© MARVEL MFG. CO., INC. MANUAL
PL/OMiW-2CYL_V2
(08/07)
G-3
4.
Slide the collar until its edge (D) is on the
desired shear length and tighten the locking
screws (B).
The sensor (C) is positioned so the work material
(A) will contact it at the desired cut-off length.
GUIDES / GUARD
The guide/guard (A) protects the operator from
the shear blades and helps provide support for the
work piece.
The guard (A) has holes to accommodate
different sized round and square bar stock.
The guide/guard (A) steadies the work stock
during the shearing process.
Important: The hold-down should not be
tightened firmly against the work stock. If it is
the material will not be sheared squarely.
To Adjust the Guide / Guard:
1.
Loosen the two hand knobs (B).
The guide/guard must be properly adjusted for
square cuts..
2.
Turn the adjusting screw (C) until the
work stock passes easily through the bar
shear.
3.
Hold the work stock square to the blade
and turn the adjusting screw (C) until the
guide/guard just touches the work stock.
4.
Tighten the two hand knobs (B) to lock
the guide/guard in place.
STATIONARY BLADE
The stationary blade needs to be replaced when
the work piece develops burrs as a result of the
shearing process or when the blade shows visible
signs of wear.
Replacing the Stationary Blade
Avoid serious injury. Turn off
the machine's power and lock
it out before adjusting or
servicing the machine.
1.
Turn
off
the
main
electrical disconnect switch and lock it in
the "Off" position.
2.
Remove the two hand knobs (C) that hold
the guard in place and carefully remove
the guard.
WARNING
A
C
A
C
B
