SPARTAN IRONWORKER
NOTCHING STATION
© MARVEL MFG. CO., INC. MANUAL
PL/OMiW-2CYL_V2
(08/07)
E-9
blade and the lower blades. If necessary,
align the bolster following the instructions
on page E-5.
10.
Adjust the stroke limits of the notching
station if necessary. See page E-6.
11.
Turn the Normal / Jog switch to the
"Normal" position.
The machine is now set up and ready for
operation. Continue with "Notching Operation"
for step-by-step notching instructions.
Notching Operation
1.
Complete steps 1 through 11 of "Notching
Station Set-up", page E-8.
Never load a work piece which
exceeds the machine's design
capacity. Serious injury can
result.
Refer to "Notching Station
Capacity", page E-7.
2.
Position the material to be notched on the
work table.
The notching station can cause
serious injury. Keep your
hands and body away from the
point-of-operation until the
notcher has stopped retracting
and you have removed your
foot from the foot switch.
3.
Press the foot switch all the way down and
hold it until the upper blade has cut
through the material. Release the foot
switch to retract the notcher.
Avoid serious injury. Notched
material will have sharp edges.
Always wear gloves when
handling the material.
4.
To continue notching the
same material, repeat steps 2 through 3.
Remember to periodically check the
alignment of the upper and lower blades.
To notch material of a different thickness
or with a different stock-guide setup, go to
step 1 of "Notching Station Set-up", page
E-8.
If you are done notching, continue with
step 5.
5.
Press the Emergency Stop pushbutton.
6.
Turn the Main Electrical Disconnect
Switch off.
7.
Close the notching station's guard.
WARNING
WARNING
WARNING
