![background image](http://html1.mh-extra.com/html/martin/90523000/90523000_user-manual_1732831018.webp)
18
General operation
When the fixture is powered up:
1 A check is performed on the software - both LEDs will blink yellow.
2 If the test is:
• Successful, both LEDs will blink green.
• Unsuccessful, the LEDs will blink yellow and red. In this case perform a DMX
upload and restart the fixture.
3 The installed firmware version number is then displayed. The number of red flashes
in the Power LED indicates the digit to the left of the decimal point and the number
of green flashes in the Data LED indicates the digit to the right of the decimal point.
For example, if the firmware version is 1.3, The Power LED flashes red once and
the Data LED flashes green three times.
4 The fixture will reset - both LEDs will blink yellow.
Appearance
Message
Power LED
Data LED
Steady green
-
Effects OK.
-
Steady green
Data OK.
-
Steady red
Invalid data/no data.
Steady yellow
Steady yellow
Upload in progress.
Flash red
-
Memory error (or - during start up - the
number of flashes indicates the number
to the left of the decimal point in the
software version number).
-
Flash green
During start up - the number of flashes
indicates the number to the right of the
decimal point in the software version
number).
Flash yellow
Flash yellow
Test/reset in progress.
-
Off
No data detected.
Flash yellow and red
Flash yellow and red
Application error (perform DMX upload.
See “Firmware updates” on page 32).
Table 4: LED status messages