![background image](http://html1.mh-extra.com/html/martin/90523000/90523000_user-manual_1732831015.webp)
Settings
15
Important! When setting the address, either use single-fixture mode or
isolate all other fixtures from the uploader.
To set the control address:
1 Prepare an upload device as described in the uploader user manual. If you know the
address to which the fixture is currently set, that is, the address to change from,
connect the uploader to the data link and use single-fixture mode. Otherwise, use all -
fixtures mode and isolate all other fixtures from the uploader. Apply power to the
fixture.
2 If using single-fixture mode, scroll to the fixture’s current (from) address and press
OK.
3 Select
D M X a d d r e s s
from the fixture menu.
4 Scroll to the desired control address and press OK.
5 Press OK again to confirm and save the setting.
P E R S O N A L I T Y S E T T I N G S
The following settings are available to modify fixture behavior.
DMX Lamp-off: When the DMX Lamp-off personality is on (the default setting),
lamp power can be turned off from the controller by setting channel 1 to a decimal
value from 248 to 255. When set to off, the lamp-off command executes only if
channels 3, 4, and 5 are set to values from 230 to 232.
DMX reset: When the DMX Reset personality is on (the default setting), the
fixture can be reset from the controller by setting channel 1 to a decimal value from
208 to 217. When set to off, the reset command executes only if channels 3, 4, and 5
are set to values from 230 to 232.
Automatic Lamp-on: When the Automatic Lamp-on personality is on, the fixture
turns on the lamp within 90 seconds of power on. When set to off (the default
setting), a lamp-on command is required to turn on the lamp.
To set a personality setting:
1 Prepare and connect an upload device as described in the uploader user manual.
Apply power to the fixture.
2 Select single fixture mode to change a setting on a single fixture, or all-fixtures mode
to make global changes.
3 If using single-fixture mode, enter the fixture’s address.
4 Select
S p e c i a l
from the fixture menu.
5 Select the desired personality and setting. (See “MP-2 control menu” on page 37.)
Press OK.