![background image](http://html1.mh-extra.com/html/martin/90523000/90523000_user-manual_1732831025.webp)
Stand-alone operation
25
S C E N E M A N A G E M E N T
Once you have specified a mix of effects, you can store the scene using the options
available under the Program menu:
•
Fewer scenes than the master fixture, it will run these in a cycle continuously, until the
master fixture signals that the program should start from the beginning again.
•
More scenes than the master fixture, then the additional scenes will never run,
because the program will reset to the first scene when the master starts its program
from the beginning.
A u t o m a t i c p r o g r a m s t a r t a t p o w e r - o n
You can specify that the program should start automatically when the fixture is
powered-on:
1 From the Stand alone menu select
A u t o p r o g . o n
.
2 Select
O n
.
S t o r e
s c e n e
Save settings in the current scene.
A d d
s c e n e
Save settings in a new scene at the end of the sequence.
I n s e r t
s c e n e
Save settings in a new scene before the current scene,
which moves up a number. Tip: Think of the Add and Insert
commands as Save commands, to be used as the last step
after programming all effects.
D e l e t e
s c e n e
Remove the current scene from memory. Scenes above the
deleted scene move down a number.
N e x t
s c e n e
Step to the next scene.
P r e v i o u s
s c e n e
Step to the previous scene.
C l e a r
s c e n e s
Remove all scenes from the fixture memory.
R u n
p r o g r a m
The only indication of what the current scene is comes from the behavior of the
fixture.
When the program is run, scenes execute in a continuous, ascending loop.
If a
cliented
fixture has:
Run the scenes in the current program.