27
LED
Shutdown Mode
Flashes
1
(-) Safety Shutdown Input (Hood)
1. Close the Hood
2. Check White/Black Wire Connection. (9-Pin Mini Black)
1. Check White/Violet Wire Connection. (9-Pin Mini Black)
(+) Safety Shutdown Input (Brake)
2. Move the Enable Toggle Switch to “On” position. (If Installed)
2
or Neutral Safety Switch Input Fail
3. Move the gear selector to “Park”/“Neutral” Position.
4. Check Black/White Wire Connection (9-Pin Mini Black)
3
No RPM or Low Voltage
Tachometer Checking Type:
Check White/Red Wire Connection
Voltage Checking Type:
Program the “Check Level” from “Hi Check Level” to
“Low Check Level”
5
Over-Rev
6
System Timed Out
7
Transmitter
8
Tach signal has not been learned
Check tach signal feature programming
The unit has the ability to report the cause of the last shutdown of the remote start system.
1. Turn the Ignition switch to “On” position.
2. Press the ( ) button on the transmitter
3. The LED will now report the last system shutdown by flashing for 3 cycles in the following grouped patterns:
Shutdown Diagnostics
Test Mode
In this test mode, this system can test the Zone 2 (Instant Ground Trigger), the Zone 3 (Door Trigger), and the
Zone 1 and Zone 4 (Optional Sensor) sensitivity. The installer can save time by testing the optional sensor sensi-
tivity and sensor without using the traditional arming/disarming procedures to test the sensors.
Turn the ignition switch from the
OFF position to the ON position 3
times leaving it in the OFF position
the third time.
OFF
ON
3X
Before 15 seconds has passed, push
and release the valet switch nine (9)
times then push the valet switch a
tenth time and hold it down until five
(5) chirps/beeps then release it. You
are now in “Test Mode”
9X + 1X (Hold)
Press the ( ) ( ) button once at
the same time. 1 LED flash 1
siren/horn chirp to indicate you are
now in Zone 2 - Instant Ground
Trigger.
Trigger Sensor Flashes
Chirps
Zone 2: Instant Ground
Trigger (Blue Wire)
2
Zone 3: Door Trigger
(Green or Violet Wire)
3
Press the ( ) ( ) button once
again. 2 chirp and 2 parking light
flashes will confirm you are now in
Zone 4 Optional Sensor Test Mode.
1. Activate the warn away: Short
Chirp.
2. Activate Full Alarm: Long Chirp.
3. Continue to test the sensor until
you reach the proper setting.
+
+
Step 1
Step 2
Step 4
Step 3
M8A-IM.qxp 4/26/05 15:56 Page 27
