23
Remote Start Operation and Feature Programming
Tachometer Detection Programming
If you have previously selected tachometer detection, you are required to program 2 additional features as enclosed.
Feature 1: RPM Learning
Turn the ignition switch from the
OFF position to the ON position 3
times leaving it in the OFF position
the third time.
OFF
ON
3X
Step 1
Before 15 seconds has passed,
push and release the valet switch
nine (9) times then push the valet
switch a tenth time and hold it
down until five (5) short
chirps/beeps + one (1) long chirp
beep is heard then release it.
9X + 1X (Hold)
Step 2
Start the vehicle’s engine
with the ignition key
(while the engine is run-
ning the parking lights
and the LED should be
flashing. If they are not
you need to re-check
your tachometer wire
connection).
START
Step 5
Press and hold the valet
switch. When the RPM
level is learned, you will
hear a long chirp/beep
and the LED will be on
steady for 2 seconds.
Step 6
Turn off the ignition to
stop the engine.
Remember, you are still in
programming mode.
OFF
Step 7
Press the ( ) button on the transmitter twice to
start the vehicle. If everything is correct, the
engine will crank and fire without over-running or
under-running the starter. If all things seem cor-
rect, press the (
) button twice to stop the
engine from running. If a cranking problem is
noticed, move to step 9 to adjust the crank
detection feature otherwise follow step 8 and get
out of the programming mode.
Press and release the ( )
buttons once. The LED will flash
once and you will hear 1 chirp/beep
to indicate that you are in “RPM
Learning Mode”.
Step 3
+
Press unlock button
before you turn on the
ignition key. 1 chirp and 1
LED flash will indicate
you are in Tach Learning
mode.
Step 8
Step 4
2X
If the engine cranks too long you may need to adjust the crank
detection level. Press the ( ) button twice to stop the engine
from running. Press the ( ) button on the transmitter to
change the crank detection level from hi to low. You will hear 2
chirp/beeps to indicate the feature has been changed to the low
selection.
Step 9
M8A-IM.qxp 4/26/05 15:56 Page 23
