20
Turn the ignition switch from the OFF position to the
ON position 3 times leaving it in the Off position the
third time.
Before 15 seconds has passed, push and release the
valet switch seven (7) times then push the valet
switch a eighth time and hold it down until four (4)
short chirps/beeps + one (1) long chirp beep is heard
then release it. You are now in stage 1 remote start
feature programming mode.
OFF
ON
3X
7X + 1X (Hold)
Remote Start Operation and Feature Programming (Stage 1)
Step 1
Step 2
Examine the two (2) feature charts enclosed and decide which features will get changed. Circling the feature to be
changed will make the programming process much easier to perform.
Stage 1: Remote Start Operation Programming
Alarm Feature Programming (Part 3)
Channel 4/5/6 Timer Control Output Programming:
1. Turn the ignition switch “ON/OFF” three times, stay in the “OFF” position.
2. Push the valet switch six times and hold it until three chirps with a long chirp is heard, then release the
valet switch. You are now in Alarm Feature 3 programming mode.
Timer Program:
1A. Press and release the transmitter buttons for four times. (4) LED flashes, (4) siren/horn chirp
indicates you are in feature channel 4 Timer Programming Mode.
1B. Press and release the transmitter buttons for four times. (4) LED flashes, (4) siren/horn chirp
indicates you are in feature channel 5 Timer Programming Mode.
1C. Press and release the transmitter buttons for four times. (4) LED flashes, (4) siren/horn chirp
indicates you are in feature channel 6 Timer Programming Mode.
2. Press and hold the valet switch, the timer will immediately start.
3. When the desired interval has passed, release the valet switch, 1 long chirp will confirm timer feature.
(Set to any interval between 1 second and 2 minutes)
Note 1:
If your built in timer controls windows/sunroof closure in your car DO NOT change the timer setting. This requires
installer-only programming. Changing the value will adversely effect operation and may cause damage.
Note 2:
Momentary Output: The momentary output selection will output a negative signal from the Channel 4/5/6 out-
put immediately when the channel 4/5/6 button is pressed and will continue until the button is released
Latched Output: The latched output selection will output a negative signal as soon as the channel 4/5/6 button
is pressed and will continue until the button is pressed again
Latched Output/Reset with Ignition: The latched/reset with ignition output selection operation just like the
latched output but will reset or stop when the ignition is turned on.
Ground Output During Start (Crank): This wire will provide a 200 mA ground output while the starter output of
the remote start unit is active. This output can be used to activate the Crank Low/Bulb Test wire found in some
GM vehicles. This wire is also referred to as the ECM wake up wire in some vehicles.
+
+
+
M8A-IM.qxp 4/26/05 15:56 Page 20
