11
Wiring
White 10-Pin Mini Connector
(continued)
Pink Wire:
(continued)
Factory Security Disarm Signal Output
This wire can be used to disarm a factory installed security system. This wire sends a negative (-) 1 second
pulse upon a remote start or remote door unlocking signal. Some factory systems must be disarmed to allow
remote starting. In most cases, this wire may be connected directly to the factory alarm disarm wire. The
correct wire will show negative ground when the key is used to unlock the doors or trunk. This wire is usu-
ally found in the kick panel area in the wiring harness coming into the car body from the door.
Start Status (Shock Sensor Bypass Control) Output:
This wire is designed to bypass an external shock sensor module. This wire will supply an output at all times
the remote start is operating plus an additional 3 seconds after the remote start unit turn off.
Orange Wire :
(-) 500mA
Grounded Output when Armed)
This wire will become grounded
when the alarm is armed. The
current capacity of this wire is
500mA. This output can control
a starter disable relay, when the
system is triggered. The vehicle
is prevented from any unautho-
rized starting. Also becomes
activated when the engine is
remote started.
White Wire: (-) 200mA Output
Dome Light Control Output:
This wire becomes grounded
when the dome light controls
circuit of the alarm is active. The
current capacity of this wire is
200mA. This wire can control
the operation of the interior
lights. An optional relay can be
used as shown.
A. Upon disarming, the inte-
rior lights will remain on
for 30 seconds.
B. If the vehicle is violated, the interior light will flash for the same duration as the siren.
87
87a
86
85
30
"START"
"OFF"
"ON"
White 6-Pin Heavy
Duty Connector
Starter
IN4003 Diode
Cut
Orange Wire
White 10-Pin
Mini Connector
"ACC"
Violet Wire
Common Door Pin Trigger
White Wire
Ground Wire or + 12V
Depending on Circuit Requirements
87
87A
85
86
30
+12V
Dome
Light
White 10-Pin
Mini Connector
M8A-IM.qxp 4/26/05 15:56 Page 11
