Voltage Detection Test and Additional Programming
If you have previously selected Voltage Detection, you may be required to program 2 additional features as follows.
Feature 1: Crank Detection Level Programming
Turn the ignition switch from the
OFF position to the ON position 3
times leaving it in the OFF position
the third time.
OFF
ON
3X
Step 1
Before 15 seconds has passed, push
and release the valet switch nine (9)
times then push the valet switch a
tenth time and hold it down until five
(5) short chirps/beeps + one (1) long
chirp beep is heard then release it.
9X + 1X (Hold)
Step 2
Press the ( ) button on the trans-
mitter twice to start the vehicle. If
everything is correct, the engine will
crank and fire without over-running
or under-running the starter.
Note: Let engine run for 10 seconds
or more to ensure proper operation.
Step 3
Remote Start Operation and Feature Programming
Tachometer Detection Programming (continued)
Feature 2: Crank Detection Level Programming
Press the (
) button on the transmitter
twice to start the engine by remote. Setting
the crank detection to low should have solved
the over-cranking problem.
Note: If the crank detection level is set to hi and the engine still will not start consistently due to a short crank time,
it is suggested that you re-program the unit to use another type of detection (either voltage or timer) to get the
engine to start consistently.
If all things seem correct, press the
( ) button twice to stop the
engine running. If a cranking prob-
lem is noticed, move to step 6 to
adjust the crank detection feature
otherwise follow step 5 and get out
of the programming mode.
Press the ( ) button on the trans-
mitter to get out of the program-
ming mode. You will hear three (3)
long chirps and get 3 parking light
flashes for confirmation.
If the engine shuts down after 10 sec-
onds you may need to adjust the
crank detection level. Press the
( ) button on the transmitter to
change the crank detection level from
hi to low. You will hear 2 chirp/beeps
to indicate the feature has been
changed to the low selection.
Step 10
Step 4
Step 5
Step 6
2X
2X
Press the (Lock) button on the transmitter to get
out of the programming mode. You will hear
three (3) long chirps and get 3 parking light
flashes for confirmation.
Step 11
24
M8A-IM.qxp 4/26/05 15:56 Page 24
