26
Returning to Factory (Alarm) Default Settings
Turn the ignition switch from the
OFF position to the ON position
3 times leaving it in the OFF
position.
OFF
ON
3X
Step 1
Push the valet switch 12 times and
hold it until six chirps with a long
chirp is hearing then release the
valet switch. You are now in the
“Return To Factory Default
Settings” programming mode.
12X (Hold)
Step 2
Press the ( ) and ( ) button on
the transmitter together for 6 seconds.
There will be 6 confirmation chirps
with 3 long chirps and 3 parking light
flashes to confirm the system Alarm
Features Programming Part 1, 2 and 3
all returns to factory default setting.
Next, go to Step 4 (see below).
+
ON
Turn On the Ignition
3 long chirps & 3 flashes of the parking lights will confirm exit of the programming mode.
Note: Waiting 15 seconds after the last command will also cause the system to automat-
ically exit the programming mode.
Step 4
Remote Start Operation and Feature Programming (Continued)
After adjusting the stat timer press the (
) button
twice on the transmitter to start the engine by remote.
Listen for an over-run or under-run indication. Re-
adjust as needed.
Press the ( ) button on the transmitter twice to get
out of the programming mode. You will hear 3 long
chirps and get 3 parking light flashes for confirmation.
Elapsed Timer Additional Programming (continued)
Step 3
Step 7
Step 8
Returning to Factory (Remote Start) Default Settings
Turn the ignition switch from the
OFF position to the ON position
3 times leaving it in the OFF
position.
OFF
ON
3X
Step 1
Push the valet switch 12 times and
hold it until six chirps with a long
chirp is hearing then release the
valet switch. You are now in the
“Return To Factory Default
Settings” programming mode.
12X (Hold)
Step 2
Press the button first, then within 3
seconds press and hold the and
buttons at the same time on the trans-
mitter for 6 seconds. There will be six
confirmation chirps with 3 long chirps
to confirm the system “Start Feature 1
and 2 Programming all returns to fac-
tory default setting.
Step 3
M8A-IM.qxp 4/26/05 15:56 Page 26
