HC1: White 6-Pin High Current Remote Starter Harness
(continued)
Some vehicles have 2 ignition wires that must be powered. Connect the “Pink” wire to the ignition 2 wire from
the ignition switch. No connection required on vehicles without second ignition.
Connect the Brown wire to the accessory wire that powers the climate control system. An accessory wire will
show +12 volts when the ignition switch is turned to the “ACCESSORY” or “ON” and “RUN” positions, it will
show 0 volts when the key is turned to the “OFF” and “START” or “CRANK” position. There will often be more
than one accessory wire in the ignition harness. The correct accessory wire will power the vehicle’s climate
control system. Some vehicles may have separate wires for the blower motor and the air conditioning
compressor. In such cases, it will be necessary to add a relay to power the second accessory wire.
HC2: White 5-Pin Power Harness
The Red/White wire has already been assembled to work with a +12 volt switched parking light system (most
vehicles). For vehicles with ground switched parking light activation cut this wire and connect it to ground.
Connect the White wire to the parking light wire coming from the headlight switch. Do not connect the White
wire to the dashboard lighting dimmer switch (damage to the dimmer will result). The limitation of the White
wire is 10 amp maximum. Do not exceed this limit or damage to the alarm and parking relay will result.
This is main ground connection of the alarm module. Make this connection to a solid section of the vehicle
chasis. Do not connect this wire to any existing ground wires supplied by the factory wire loom, make the
connection to the vehicle’s chasis directly.
By default, the Brown wire is the positive (+) output
connection for the siren. Current capacity is 2 amps.
Make connection to the (+) red wire from the siren.
Connect the (-) black wire coming from the siren to a
good chassis ground.
Option: (+) Horn Output (See “Alarm Feature
Programming” to change the function to horn)
Connect this wire to the existing vehicle’s horn relay
trigger. Some vehicle horn systems may be (-) trigger
and a relay will need to be added for proper operation
as shown.
The “Red” wire supplies power to the system. Connect this wire to a co12 volt source.
87
87a
86
85
30
Brown
Wire
To Ground
To Horn
+12V or Ground
Depending on
System Requirements
Fuse
White
5-Pin
Connector
8
Wiring
(continued)
Pink Wire: Ignition 2 Output
Brown Wire: Accessory Output, Heater/AC Output
Red/White Stripe: Parking Light Relay Input
White Wire: Parking Light Relay Output, + or - Selectable
Black Wire: System Ground
Brown Wire: (+) Programmable Output - Siren Default Setting
Red Wire: System Power, +12V Constant
