25
Shock Sensor Testing Procedure:
Follow the procedure to get into “Remote Feature Programming (Group 3)” mode. Press the (*) button to get
2 Chirps/Beep confirmation. Adjust the sensor with a small flat blade screwdriver to gently turn the sensitivity
screw in the “+” or “–” direction to achieve the desired sensitivity of both zones.
Note 1: Light impacts to the vehicle will activate the “warn-away” stage of the shock sensor. Each time the
warn-away stage is activated, you will hear a short chirp/beep.
Note 2: A more forceful impact will activate the “alarm trigger” stage of the shock sensor. Each time the alarm
trigger stage is activated, you will hear a long chirp/beep.
Note 3: The shock sensor can be adjusted at any time by entering “Alarm Feature Programming” Part 3 and
following the above directions.
Note 4: If you have (2) sensors installed, set sensor #1 first, then unplug it from the control module. Plug in
sensor #2 and set the sensitivity. When done, plug in sensor #1.
Turn On the Ignition
3 long chirps and 3 flashes of the parking lights will confirm exit of the
programming mode.
Note: Waiting 15 seconds after the last command will also cause the
system to automatically exit the programming mode.
Step 4:
Exit Programming
Alarm Feature Programming (Group 3)
(continued)
