21
With the ignition switch in the OFF position, turn the
ignition switch On - Off - On - Off - On.
Before 15 seconds has passed, push and release the
valet switch 3 times. Hold the button down on the 3rd
press.You will hear a long chirp from the siren/horn
Release the button. You are now in “Programming the
Transmitter” mode.
Step 1
Step 2
The transmitters included with this system have been pre-programmed and should not need re-programming.
Note: This system will accept codes from 4 transmitters. If more than 4 transmitters are programmed, the system
will only operate from the last (4) programmed transmitters.
Follow the enclosed procedure to program additional transmitters:
3X
2X + 1X (Hold)
Step 3A
Press the “Lock” button on the first
transmitter until you hear a
confirmation chirp/beep. The
transmitter is now coded into the
system.
Step 3B
Repeat Step 1 for each additional
transmitter.
Step 4:
Exit Programming
When finished, either turn off the
ignition key or wait for 15 seconds
to get out of transmitter
programming mode. You will hear 3
long chirp/beeps to indicate you are
out of the “Programming the
Transmitter” mode.
Programming the Transmitter
